How To Install Asa In Gns3

For the techs who are new in the world of "Calculator Networks", this guide will help you to know how you lot can install Cisco ASA in "GNS3", this for people who wants to learn about Cisco security certification, and that volition help to salve some coin instead of buying real Cisco ASA, as most of that is on a virtual environment.

Install Cisco ASA in GNS3

1. Start, you volition need to Download "ASA" OS, and in one case you download it, Unzip it.

2. Run "GNS3", and go to "Edit", so select "Preferences", Click on "QEMU VMs", and so click "New".

iii. Make sure to set type as "ASA eight.4", and so hit Next.

iv. Proper noun your VM, then click Next.

5. On "QEMU binary and Memory" page of the installation, set the corporeality of RAM retentiveness, and leave everything else equally default.

6. On "Linux kicking specific settings" folio of the installation sorcerer, brand sure to select the files for Initial RAM disk & Kernel Epitome, from the files yous had downloaded at the start.

seven. Now your ASA emulator will appear on the "QEMU VM templates", apply the settings you had set up.

8. Now you are ready to launch your ASA and verify that all the settings and configurations are "OK" with "show version" control, similar the below screenshot.

Abdelrahman Reda is a Motivated Back up Engineer with 6+ years of corporate and consumer support experience. His experience related to administration of Network, NOC support, computers and anti-virus server, data entry, networking sites, remote support.

Source: https://www.avoiderrors.com/how-to-install-cisco-asa-in-gns3/

Posted by: beamonsomint.blogspot.com

Share this post